Acer Aspire TimelineX 4830T-6682 Battery Replacement

Geschrieben von: Rachel Wagner
  • Kommentare: 2
Acer Aspire TimelineX 4830T-6682 Battery Replacement

Schwierigkeitsgrad

Moderate

Schritte

8

Zeitaufwand

7 Minuten

Einleitung

  1. eixbsEc2JE6JV463
    eixbsEc2JE6JV463
    FWWdCLtWLxJOdAeq
    FjPhDifbfTug3mQo

    • Remove the single screw with a Phillips #0 screwdriver.

    • Use a plastic opening tool on the upper part of the panel to remove it and access the RAM.

    • The other way to remove the panel is by sliding it away from the laptop. The difficulty of sliding it depends on the condition of your laptop.

  2. nufNqSlFmNWipmbM
    nufNqSlFmNWipmbM
    sRo5UK541mQRcPNC
    Z4gelXYj41jHVVgj

    • After the panel has been removed, locate the RAM. It should be on the lower right.

    • There are pins around the RAM that need to be pulled back. After the pins are removed, pull the RAM chip towards you to remove it.

  3. Z4ekqGWtwUY1R3bw

    • Remove the eleven screws that hold that back panel to the laptop using a J0 Phillips screwdriver bit.

  4. bSeCc5priALogyl2
    bSeCc5priALogyl2
    QSQDefSn6uvQpeRq
    uUAEC3d2eMeUIlaT

    • Place the laptop in the upright position, the lower front touchpad panel should be easily detatched at this point.

    • Remove the lower front touchpad panel by using an angled tweezers to disconnect the only wired tape connected to the motherboard.

  5. ehUWpnSLXfJTwUOS

    • Next, disconnect the 4 wired tapes of the keyboard from the motherboard just like we did with the lower front touchpad panel.

    At this step 3 additianal screws have to be removed on the lower left, middle and right side (which are also visible on the image but not marked) before the keyboard cover can be removed!

    Robert -

  6. SPIJcGAKjPPQpybD
    SPIJcGAKjPPQpybD
    I6kCToqk5HQqqOLG

    • Finally, using an opening tool, gently pry along the edge of the keyboard to separate it from the laptop.

  7. YLrHQvBpm33abQhe

    • The battery will be on the side closest to the screen.

    • Gently lift it out. It will still be attached by white, red, and black wires.

  8. PCGkQiqZQg3sU1qe
    PCGkQiqZQg3sU1qe
    2ywHUqWC4bSBK6aF

    • Pull the white plug, it should easily detach.

    • Remove the battery from the device.

Abschluss

To reassemble your device, follow these instructions in reverse order. When reattaching the back panel, make sure to pry out the pwr on/off slide switch near the center. The back panel switches it off when closing, and there is no other way to avoid it.

Tinte & Feder

Rachel Wagner

Mitglied seit: 25/09/17

277 Reputation

Ein Kommentar

Great instructions but there is one step missing. There are three more screws holding the key board on. Once you remove the mouse they are under that part. Other than that thanks.

Chris Webber -