Einleitung

The Acer Iconia Tab uses a Li-Po 3260 mAh battery that is screwed into the device.

  1. iyRAPKJkD2ZALLMF
    iyRAPKJkD2ZALLMF
    xeWlnQBDMSST6djU
    • With the plastic opening tool pry open the grey plastic siding on both sides of the tablet.

  2. iwhjF2rPTWbNIxvE
    iwhjF2rPTWbNIxvE
    RIHfhmWyvyVbUXgD
    • Using a Phillips #00 screwdriver remove the 4.0 mm screws on the sides of the tablet.

    • There are two screws on each side of the tablet that need to be removed before the back casing can be removed.

  3. PuEwdQKiyPEasdmN
    PuEwdQKiyPEasdmN
    UIi2HZfW1tiTNkOL
    • Once the 4 screws have been removed use the plastic opening tool to pry open the device on the side of the device.

    • Be careful prying on the sides where you removed the screw as the plastic casing is not very strong and may break.

    • After prying open the case with the plastic opening tool carefully remove the case from the device and place the device face down on its screen.

  4. DM62HPBP5TYUdYTL
    DM62HPBP5TYUdYTL
    lbTCrEqaNnfXHNOT
    • Using a Phillips #00 screwdriver remove the 4.0 mm screws holding the battery in place.

  5. mXkrLsJGRhipypvO
    mXkrLsJGRhipypvO
    GlOYnutgL5djjYJH
    • Lift the battery out of the device, and disconnect the cable attached to the motherboard by pulling it out to the side not lifting it up.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Jaimie Payne

Mitglied seit: 07/03/16

477 Reputation

2 Kommentare

Instructions should point out that when removing the device from the case that prying tool must got between the gasket and plastic case, NOT between the screen and the gasket. I hope my cracked screen will still work!

Michael Burlovich -

What are the specifications to purchase a new battery for my icona Acer tablet 200 ?

Gloria Regester -