Einleitung
Prerequisites
- Follow the procedure in Before working inside your computer.
Werkzeuge
-
-
Remove the two screws (M2.5x5) that secure the base cover to the palm-rest and keyboard assembly.
-
New line. Loosen the two captive screws (M2.5x8.5+3.5) that secure the base cover to the palm-rest and keyboard assembly
-
Loosen the four captive screws (M2.5x1.7+3.3) that secure the base cover to the palm-rest and keyboard assembly.
-
-
-
Using your fingertips, pry open the base cover from the middle of the front edge of base cover, and then pry the left and right sides of the base cover.
-
Lift the base cover off the palm-rest and keyboard assembly.
-
-
-
Disconnect the battery cable from the system board.
-
Turn your computer over and press the power button for 20 seconds to drain the flea power
-
-
-
Lift the system board Mylar to access the memory module.
-
Use your fingertips to carefully spread apart the securing-clips on each end of the memory-module slot until the memory modulepops up.
-
Remove the memory module from the memory-module slot.
-
To reassemble your device, follow these instructions in reverse order.
