Amazon Echo Dot 3rd Gen Disassembly

When Prying the bottom off, insert the Metal Spudger under the bottom where the ports are

Avoid letting the Adhesive touch anything, lay the plate on the branded side

If the adhesive is to strong use a hair dryer to soften it

Use a TORX T6H bit to remove the four screws on the bottom

When all the screws are taken out lift up and the covering should slide off

Remember to un latch the ribbon cable before pulling the circuit board up

To get the further screws on the bottom, use a 4 mm nut driver and put the TORX bit in the nut driver as an extension

Pull up on the metal to release the top from the rest

Undo the four screws the remove the white defuser piece (I lost a screw)

The two should separate if you hold the edge, if it doesn't push a button on top and it should pop out