Apple TV 1st Generation AirPort Card Replacement

Geschrieben von: ropel
  • Kommentare: 0
Apple TV 1st Generation AirPort Card Replacement

Schwierigkeitsgrad

Moderate

Schritte

7

Zeitaufwand

Keine Schätzung

Einleitung

Replace the AirPort card in your Apple TV 1st Generation.

  1. gTflMGU1GDKH1UAF

    • Flip the Apple TV over so that the bottom of the unit is facing up.

    • You need to remove the rubber base to get access to the screws.

    • Starting at one side of the device, use a hairdryer or a heat gun to soften the adhesive holding the rubber base in place.

    • The rubber base will be hot after heating, take extreme caution while proceeding to avoid personal injury.

    • While the adhesive is still warm, peel the bottom of the rubber base upwards to detach it from the metal plate.

    • The rubber base can tear if the adhesive hasn't been softened enough.

    • Repeat the procedure described above until the rubber base has been completely removed.

  2. WioHQQFh1XKyBajy

    • Remove the four T10 Torx screws that secure the lower case to the upper case.

  3. FXlCjU12J1gYLa5T

    • Carefully lift the lower case from the upper case enough to allow access to the internals of the Apple TV.

    • Be aware that the hard drive is physically attached to the lower case and that a ribbon cable runs from the drive to the logic board in the upper case.

  4. N3pRWNSQOGGDcX4e
    N3pRWNSQOGGDcX4e
    ARGsWiEFTPRgevA5

    • Carefully pull the hard drive data cable straight up from its socket on the logic board.

    • During reassembly, make sure the hard drive data cable is firmly seated in its socket on the logic board; otherwise, during boot-up you will see a flashing question mark "?".

  5. M2fPmIXvCkIPTi3V

    • Pry the AirPort antenna cables straight up from their sockets on the logic board.

  6. HEcreBKgZEbogB5h

    • Remove the single T8 Torx screw securing the AirPort card to the logic board.

  7. h4MTdtpCgDoECAw2

    • Cautiously lift the AirPort card and pull it straight away. Slide it from its socket on the logic board.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

ropel

Mitglied seit: 11/11/09

113 Reputation

0 Kommentare