Einleitung

This guide will show you how to replace the hard drive from your Asus ROG FX60VM laptop.

The hard drive is a component that stores and retrieves data in your computer. If your hard drive is running low on storage or failing (making irregular noises or constantly crashing), it may be time to replace your hard drive.

However, before you start, make sure you've made a copy of your data so you don’t lose it while you’re doing the replacement. Also be sure to power off your device and unplug from the power outlet before you begin the repair.

  1. eT4XAlaqPHlnsbPM
    eT4XAlaqPHlnsbPM
    hfCDRlpTRKbFnQsp
    • Before disassembling the laptop, turn the laptop off and make sure it's unplugged from the power supply.

  2. Qrx6kxyXbhXdvhgb
    Qrx6kxyXbhXdvhgb
    C5OMfVOrTVAAaisA
    AtUHIPfYN5owjO3M
    • Flip the laptop over so the back case is facing up.

    • Remove the ten 2.5 mm screws from the back case using a Phillips #0 screwdriver.

    • Use a plastic opening tool and picks to pry the back panel off of the device.

  3. LRORiTTVTKXVX4jV
    LRORiTTVTKXVX4jV
    I5BKLC6hGgU1l4a4
    Ef5JiPxvmw6w1aMe
    • Put the tip of Halberd spudger under the battery connector and lift it gently to disconnect it from the motherboard.

    • You may need to wiggle the spudger up and down in order to disconnect the battery connector.

  4. x5lZ2VTtlRrju3j2
    x5lZ2VTtlRrju3j2
    eRrpRtuI3AwjThB4
    • Remove the four 3.0 mm screws from the HDD case using a Phillips #1 screwdriver.

  5. 3OdAFZONjkLaKBXl
    3OdAFZONjkLaKBXl
    RLeyAGrwuHAjJOiA
    cxQNZfSZFI5OXQgr
    • Do not lift the HDD up, as you may damage the connector highlighted in red.

    • Hold the back of the HDD , and slide it out of the port to disconnect it from the motherboard.

  6. 11mjpy1PYrVeJXuv
    11mjpy1PYrVeJXuv
    DqcrbxwbXyL3OIa1
    kWVYZsDAxtgKPwgO
    • Remove the two 3.0 mm screws on each side of the HDD mounting bracket using a Phillips #1 screwdriver.

    • Lift the HDD out of the mounting bracket, and install a new HDD or SSD to the mounting bracket.

Abschluss

To reassemble your device, follow these instructions in reverse order.

After install a new HDD or SSD, for better performace, initialize the new disk.

Take your e-waste to an R2 or e-Stewards certified recycler.

JingZhao Liang

Mitglied seit: 27/06/22

163 Reputation

Ein Kommentar

Thank you so much JingZhao Liang for the concise and to the point guide. It's easy to follow and I am very impressed that you mentioned how to dispose the e-waste properly in conclusion part.

Tayyaba Riasat -