Einleitung
This tutorial demonstrates how to remove the motherboard from your laptop. Doing so allows you to upgrade the CPU, implement a higher quality graphics card, and improve the operating power of your computer.
Werkzeuge
-
-
Using the Phillips #0 screwdriver, remove the seven 14 mm screws on the bottom of the laptop.
-
Then use the Phillips #0 to remove the three 4 mm screws on the bottom of the laptop.
-
-
-
Insert a plastic opening tool between the keyboard and base of the laptop to pry the keyboard away from the base. Do this around the entire perimeter of the laptop.
-
This disconnects the face of the keyboard. Gently lift the keyboard up to expose the motherboard.
-
-
-
Gently lift the keyboard to access the three ribbon cables connected to the motherboard
-
Using precision tweezers, flip up the white and black retaining flaps on the ZIF connectors that hold the two smaller ribbon cables in place.
-
Gently pull the ribbon cables from their sockets on the motherboard.
-
-
-
Push the two white clamps on the large ZIF connector towards the screen.
-
Gently remove the track pad ribbon cable from its connector.
-
-
-
Pull the two tabs holding the battery in place and lift the battery up. It should remove easily.
-
-
-
Use a Phillips #0 screwdriver to remove the thirteen black 4 mm screws from the face of the motherboard.
-
Use a Phillips #0 head screwdiver to remove the four silver 4 mm screws from the face of the motherboard
-
Use a Phillips #0 head screwdriver to remove the one black 4 mm screw from the indented area above the fan.
-
-
-
Use the precision tweezers to flip the black switch holding the film connected to the USB port.
-
Gently remove the film from it's connection to the motherboard.
-
-
-
Gently pull the thick wire in between the fan and the motherboard. To release the wire connected to the motherboard, gently pull towards the cooling fan.
-
-
-
Gently pull the red, black, and white wire found on the top right-hand corner of the motherboard.
-
-
-
Lift the top right corner of the motherboard to access the final wire.
-
Gently remove the wire from the port connecting it to the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
2 Kommentare
Hello, I am interested in know how could I change the diode m51j, due to the volts from the USB don't function it, please could you help me, my email address is ing.gabriel.alcazar@gmail.com if you have the technical manual will be great
Thank you
This is also the same disassembly for upgrading the system memory. DDR3L PC3L-12800 1600MHz SODIMM, 16 GB max, 2 memory slots.
pacerbob -
Can I get a link to the replacement fan, please?
Riley's Alias -