AvertX HD810 Dome Cover Replacement

Geschrieben von: Elisabeth Garcia
  • Kommentare: 0
AvertX HD810 Dome Cover Replacement

Schwierigkeitsgrad

Easy

Schritte

3

Zeitaufwand

4 Minuten

Einleitung

This guide covers removing the clear dome cover for the AvertX HD810 security camera. You need a T10 Torx security screwdriver and a replacement dome cover for the camera. It's advised to have the camera turned off for this procedure.

  1. JhDLhO2FWNoxXYnV
    JhDLhO2FWNoxXYnV
    giL1lkqVXFJPfOXG
    s1g3En5PqmBva3k1

    • Lift off the paintable snap-on cover from the AvertX HD810 dome security camera.

    • Optimally, the device should be turned off and the PoE (Power over Ethernet) unplugged.

  2. 5ZWEL3VhISQHUsKn
    5ZWEL3VhISQHUsKn
    eWCSMCpNuFXZBSj3

    • Loosen both 10mm screws on either side of the clear dome cover housing using a T10 Torx security screwdriver.

    • It is not recommended to remove the screws from the clear dome cover housing. The screws are apart of the cover and not intended to come out.

  3. jEsVy4SqefG2RWWJ
    jEsVy4SqefG2RWWJ
    VsYdICH5FFFuVHo2
    IXvwHk5U5hEgjdwR

    • Gently pull off the clear dome cover from the camera base.

Abschluss

You've successfully replaced your AvertX HD810 clear dome cover when you've snapped back on your paintable snap-on cover. You can reassemble your device at any point by following the steps in reverse order.

Tinte & Feder

Elisabeth Garcia

Mitglied seit: 18/01/17

207 Reputation

0 Kommentare