Bell and Howell DNV16HDZ Hand Strap Replacement

Geschrieben von: Jerry Hadjah
  • Kommentare: 0
Bell and Howell DNV16HDZ Hand Strap Replacement

Schwierigkeitsgrad

Moderate

Schritte

4

Zeitaufwand

5 Minuten

Einleitung

  1. SGLn4yl5FcUkrPry
    SGLn4yl5FcUkrPry
    YKYWbvZIJlBFIhuk

    • Remove the five 30mm Phillips #0 screws on the bottom of the camera.

  2. 4Q4wScChpAdGOFVv

    • Use a plastic opening tool to disconnect the internal hinges that snaps the camera into place.

    • Using a plastic opening tool is important since a metal one will scratch or damage the thin plastic hinges that hold the camera together.

  3. gpStOUcsTtOBoabC

    • It will still be connected by a plastic film. This can also be disconnected by pulling up the white part where it connects to the light circuit board.

  4. GpBulUDUMLeh6thT
    GpBulUDUMLeh6thT
    SAtGrRX6rwEQ3KUh

    • Pull the side with the hand strap upwards to disconnect it from the camcorder.

    • Unscrew the four 40 mm Phillips #0 screws.

    • Add the new hand strap now.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Jerry Hadjah

Mitglied seit: 04/03/16

525 Reputation

0 Kommentare