Brother PT-110 Print Roller Lever Replacement

Geschrieben von: Kimberly Larsen

Kommentare: 8

Brother PT-110 Print Roller Lever Replacement

Schwierigkeitsgrad

Moderate

Schritte

Zeitaufwand

5 - 20 Minuten

Einleitung

The entire motor/gear assembly housing should be removed before starting.

Werkzeuge

Schritt 1

Push on the side of the cover, and remove it.

Schritt 3

Unscrew the two 9 mm Phillips #1 screws from the top and bottom.
Total: 2 x Screws

Schritt 4

First: To separate the top cover from the body, insert a spudger between the two halves.
Gently twist the spudger until the two halves separate. Do this in multiple spots around the perimeter of the cover to distribute the pressure.
DO NOT PULL HALVES APART. There are wired connections inside that must be disconnected before halves can be fully separated.

Schritt 5

Gently separate the two covers, ensuring wires are not taut.

Schritt 6

Gently grasp the ribbon wire and top cover, then gently pull the ribbon wire out of its connection.

Schritt 7

Carefully pinch the top of the connector.
Pull perpendicular to the device until the wire is disconnected.
It may require more force than expected to disconnect the wires.

Schritt 8

Unscrew the three 9 mm Phillips #1 screws shown.
Total: 3 x Screws

Schritt 9

Using the metal spudger, swivel the pin so that the print roller lever loosens.

J'aimerais bien trouver cette piece du numéro 10 .la piece de plastique blanche. Le petit bras est brisé. Oui je peux trouver ces piece .Merci vous pouvez me réponds à Pierrepicotte@gmail.com serait apprécié

Pierre Picotte - 12/07/19

If the roller is broken, where do you buy a new one? My roller mechanism doesn't move but looks in good condition...

gsberens -

Did you ever find a source for the broken roller ??

Barry Press -