Brother PT-D200 Keyboard Replacement

Geschrieben von: [deleted]
  • Kommentare: 0
Brother PT-D200 Keyboard Replacement

Schwierigkeitsgrad

Moderate

Schritte

7

Zeitaufwand

10 - 15 Minuten

Einleitung

This guide will lead you through the steps for replacing the keyboard on your Brother PT-D200.

  1. qQOTWnCVigvZBqFW

    • Flip the device over and press down on the indication arrows located at the top center of the back cover and pull it open.

  2. SOfK1tDoqtUHHZuT

    • Remove the six AAA batteries.

  3. ZrMw1CYx5WI1pDT2

    • Use the Helping Hand 1/4" screwdriver to unscrew the six 3/16" corner screws.

  4. PSUZGkysoVixXjUQ

    • Close the back cover and then flip the device over and separate the top half from the bottom half as shown.

    • Be gentle when lifting the top of the device, there is a ribbon cable attaching the two halves together.

  5. QiL1YeZvEBljJcVd

    • On the top portion of the device there are four grey clips locking the faceplate in place. The two top clips are circled in the image. The two others are located in the other corners of the device.

  6. uymJgoEwOchfjelH
    uymJgoEwOchfjelH
    BbggFgP1oBRWMSNC

    • Pull the clips inward two at a time, first the top then the bottom, to snap the face plate off.

  7. uq1ZPyTFpM2WWGYE
    uq1ZPyTFpM2WWGYE
    V4UHV4IGISykkQe5

    • Peel off the rubber keyboard of the device.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

[deleted]

Mitglied seit: 24/01/14

301 Reputation

0 Kommentare