Einleitung
This will allow you access to the ports, or if you need to replace the dust cover, will allow you to do that.
Werkzeuge
-
-
Use a thin piece of plastic, spudger, or fingernail (if you have them) to lift up the edge of the grip, and pull up slowly.
-
Repeat for the other two grips
-
Remove the adhesive like you would rubber cement, just rub your finger against it, it will come off.
-
Optionally throw the balled up adhesive at people pretending its a booger :)
-
-
-
Using a Spudger, fingernail, or other thin plastic tool to wedge the panel off of the camera
-
Start at the camera's front. Pulling on the rubber av-cover may be enough to get it to move off the body
-
Only pull about 1/4" (3-5mm). There is a tab that will need to slide out
-
-
-
At this point, the only thing holding on is the dust-cover is hooked onto the front panel
-
Slide down to remove without damaging the cover. (see photo with cover removed)
-
You can see how the cover, and side piece fit together in the second image.
-
To reassemble your device, follow these instructions in reverse order.
