Einleitung
You need to remove the casing before you can start getting into any internal parts of the Camera. This can also be a good start to helping the camera dry out in case of a water accident.
Werkzeuge
-
-
Unscrew the six screws on the casing. Two are on the bottom as pictured; two more are on each side of the camera.
-
-
-
Find the line that separates the casing into its two halves. Hold each half separately, and gently pull apart.
-
Note that there is a small metal clip holding the two halves together. It might help to press down on the back half (indicated) while pulling upward slightly on the front half.
-
-
-
Remove the square, clear, rubber protector from the front of the logic board. This is not necessary to remove, but can easily fall off and get lost during later steps.
-
-
-
When you reassemble the camera, make sure the switch on the casing matches the position of the switch on the camera internals.
-
The black viewfinder padding can easily fall off the casing. Make sure you don't lose it when moving around parts.
-
To reassemble your device, follow these instructions in reverse order.
