Canon PowerShot SX120 IS Back Cover Replacement

Geschrieben von: Maria
  • Kommentare: 1
Canon PowerShot SX120 IS Back Cover Replacement

Schwierigkeitsgrad

Easy

Schritte

7

Zeitaufwand

20 - 30 Minuten

Einleitung

Disassemble the back cover of the Canon PowerShot SX120 IS in order to open the camera and access the inside components.

  1. 6XeM2jC2CeDfylDF

    • Turning the camera so the screen is facing you.

    • Remove the two black 3.4 mm screws with a Phillips #00 screwdriver.

  2. XSV1vMNeuVZdgTKL

    • Put the camera with the lens facing up and turn it to the side so the DC IN A/V OUT DIGITAL is facing you.

    • Remove the single black 3.4 mm screw with a Phillips #00 screwdriver.

  3. uQMyIlfsMcbaLyGv
    uQMyIlfsMcbaLyGv
    HvEgTyeumfjpaGBF

    • Put the camera with the lens facing up, and turn it to the side where the battery cover is located.

    • Remove the three black 3.4 mm screws with a Phillips #00 screwdriver.

  4. ZEGPArJuQpgDX3YD
    ZEGPArJuQpgDX3YD
    C5TQELHJQQsaW1PU

    • Put the camera with the lens facing up, turn it to the side where the compartment of the battery (CR1220) for time/date is located.

    • Remove the single black 3.4 mm screw with a Phillips #00 screwdriver.

  5. 5hQyJ2IJeveXIQZm

    • Put the camera with the lens facing down, and turn it to the side where the DC IN A/V OUT DIGITAL cover and the silver lanyard attachment are located.

    • Open the DC IN A/V OUT DIGITAL cover.

    • Remove the single black 3.4 mm screw with a Phillips #00 screwdriver.

  6. ZfUd2yMgcGfo4nqy
    ZfUd2yMgcGfo4nqy
    e14BhmaiOjjinZv6
    VCwKOGo3WOOFxIZ5

    • Turn the camera with the lens facing down.

    • Opening the camera can be challenging. Don't get discouraged if it takes you a few tries before the camera is opened.

    • Use the iFixit opening tool to make leverage. Insert the opening tool in the seam where the front case and the back case assemble.

    • Carefully put pressure on the opening tool so the cover can gradually open.

    • Slowly slide the opening tool along the gap and around the edge of the camera.

    • When you are dissembling the back cover, the DC IN A/V OUT DIGITAL cover will also disassemble and fall off.

  7. rjQp26DxRf3Tq3XP

    • Remove the back cover and the DC IN A/V OUT DIGITAL cover from the camera.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Maria

Mitglied seit: 13/03/14

851 Reputation

Ein Kommentar

It took me 2 hours to install the battery door. I dropped one screw and could not find it any more it just vanished.

I was lucky to find one just like the one I lost after a half hour search.All in all I did a pretty good good job for an

auto mechanic .Thanks very much for your help, it was very easy to follow your instructions.

Fred Czarnik

Frederick Czarnik -