Einleitung
This guide will show how to remove the metal plate that leads to the inside of the camera. This will allow access to the lens and motherboard.
Werkzeuge
-
-
Remove 2-3.4 mm screws that secure the back panel using a Phillips #000 screwdriver.
-
Remove 4-4 mm screws on the left and right sides of the camera using a Phillips #000 screwdriver.
-
-
-
Remove 2-4 mm screws that secure the bottom of the camera using a Phillips #000 screwdriver.
-
-
-
Pull back the rubber facing to access the A/V and HDMI output compartment.
-
Remove 1-3.4mm screw inside the compartment using a Phillips #000 screwdriver.
-
-
-
Remove 3-4.4 mm screws that secure the small metal plate using a Phillips #000 screwdriver.
-
-
-
Remove 6-4.4 mm screws that secure the metal cover using a Phillips #000 screwdriver.
-
Remove 2-2.5 mm screws that secure the back panel using a Phillips #000 screwdriver.
-
After all 8 screws are removed, pull the metal plate out with your fingers.
-
To reassemble your device, follow these instructions in reverse order.
