Canon Powershot SD550 Outer Case Replacement

Geschrieben von: Matthew Theiss
  • Kommentare: 1
Canon Powershot SD550 Outer Case Replacement

Schwierigkeitsgrad

Easy

Schritte

6

Zeitaufwand

15 Minuten

Einleitung

The outer case of the PowerShot SD550 is the part that takes the greatest beating. Every time the camera falls, it lands on its case. Some common problems include cracking and paint wear.

  1. O4N4YhNqefgppANR

    • Remove the battery and SD card from the camera.

  2. RcfWZ4sVXCwdHkJw

    • Remove the three 3.8 mm screws from the underside of the camera.

    • Each of the screws is slightly different, so it is important that you note the original location of each screw.

  3. mFXsf6DuNvpBvWSM
    mFXsf6DuNvpBvWSM
    LoWipxOowNgnjGpj
    2tPxL1WggNERhuyL

    • Remove the 3.2 mm screw from the right side of the camera.

    • Remove the 2.2 mm screw from the right side of the camera.

    • One of these screws is hidden under the USB port cover.

    • Lift the side panel off.

    • Remove the 1.8 mm screw from underneath the side panel.

  4. l5PQGGmVqpfpGrF2
    l5PQGGmVqpfpGrF2
    F3BUqEqHERjbmHGe
    BBC46DSkXE2chl5H

    • Remove the two 2.2 mm screws from the left side of the camera.

    • Lift the plate from the camera.

  5. XZbXPoKfJfmcOeKN
    XZbXPoKfJfmcOeKN
    ndlQK5QfmHAJGKjG
    MWWjUkluRo2cigTG

    • Gently lift the rear of the case to remove it from the camera.

  6. iTQeOPAORDIotnCN
    iTQeOPAORDIotnCN
    Wug1VjVVJPokWyJ2
    MFSQtIRSFMstdgF2

    • Remove the front of the camera body.

    • Be sure to keep track of the rubber ring.

    When removing the front, this little clear rubbery piece might fall out.

    Cody -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Matthew Theiss

Mitglied seit: 14/04/11

149 Reputation

0 Kommentare