Canon Vixia HF R500 Battery Charger Replacement

Geschrieben von: James Walker
  • Kommentare: 0
Canon Vixia HF R500 Battery Charger Replacement

Schwierigkeitsgrad

Moderate

Schritte

13

Zeitaufwand

15 Minuten

Einleitung

The charging port of the Canon Vixia HF R500 is connected by a fragile ribbon cord. This cord can become damaged or disconnected preventing the battery from charging. This guide will show you how to check the connection.

  1. TNBlaqhKpnuSFLbT
    TNBlaqhKpnuSFLbT
    cOEWZxsvIKGdSwNM
    DYHJRHqJBieZ6YxL

    • On the right side of the camcorder remove the grip belt.

  2. DBHGGO35PsHCGsM4

    • Hold on to the battery.

  3. sqaUcHHGCYrDiScB

    • On the bottom of the battery hold the battery release switch.

  4. IyPOnMtKquNyHXYx

    • Remove the battery slowly away from the camcorder.

    • Removing the battery quick or in a different angle may cause sparks and damage to device.

  5. N2nnZBTjioT1XkXy
    N2nnZBTjioT1XkXy
    l5P1uZoIDVYCbkvy

    • Remove the two 8mm Philips #000 screws on the side where the grip belt was located on.

  6. m1sCJh2iNElEUgVt

    • Remove the two 4mm Philips #000 head screws from the bottom of the camcorder.

    • A hidden 4mm Philips #000 screw is shown under the black plug shown.

  7. HUOKwgCMMBrWRBOT

    • Remove the side piece plate.

  8. 6dutPDyv2Q24XcqB

    • Near the LCD screen, remove the three 7mm Philips #000 screws in the picture shown.

  9. vHlDLYZH6SIrwJVe

    • Carefully place the camcorder where the inside of the device is facing upwards and remove the 3mm Philips #000 screw shown.

    • Do not use strong magnetic parts on the inside, as they may damage the device.

  10. Q6P4YmTdaxQyACfn

    • Using the spudger, pull the tab shown to start removing the ribbon cable.

  11. UUW5IDDDraxM1wtL
    UUW5IDDDraxM1wtL
    DxZOVDOoYKuUmVEx
    2hrOYlBrBrKwioZO

    • Using the Spudger, carefully remove the two ribbon cables that are connected to the top of the device.

  12. cZcOGfGaHo6kLcXZ

    • Remove the top piece.

  13. TqS2HiVrgOvoVZQo

    • Ensure the ribbon cord is connected

    • Check the condition of the ribbon cord and replace damaged cord.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

James Walker

Mitglied seit: 29/01/16

461 Reputation

0 Kommentare