Clarke Floor Sander 07014A 2012 Blower Housing Replacement

Geschrieben von: Arthur Shi
  • Kommentare: 1
Clarke Floor Sander 07014A 2012 Blower Housing Replacement

Schwierigkeitsgrad

Moderate

Schritte

6

Zeitaufwand

Keine Schätzung

Einleitung

This guide shows how to remove and replace the blower housing for a Clarke Floor Sander 07014A.

  1. LY2SXYvYj3wa4kT1
    LY2SXYvYj3wa4kT1
    sccVXIFnciYAPPBH

    • Before you begin, be sure that the sander is unplugged and powered off.

    • Twist and pull the dust bag collar to disconnect it from the elbow pipe.

    • Remove the dust bag.

  2. UlQNb5yPTFH6ggmk
    UlQNb5yPTFH6ggmk
    wRf5juBp2AJTqqlP

    • Peel the rubber sleeve down from the elbow pipe to reveal the pipe socket.

  3. MIoWLCMMVAvBXR2I
    MIoWLCMMVAvBXR2I
    k1xqm1TB5bxI5uoj
    WaMYsAYZ6FWkn6SH

    • Grasp the elbow pipe with your hands and pull up while twisting to disconnect it from the blower housing.

    • Remove the elbow pipe.

  4. cnBPtsSTYSfGeOnS
    cnBPtsSTYSfGeOnS
    FOGDhWHkkUW1OkgO
    pIDwgEQURnuROdd1

    • Twist and pull to disconnect both suction hoses from the blower housing.

  5. vwgkXA3Ps3GBwLeO
    vwgkXA3Ps3GBwLeO
    OfojQ6LpHTwheEsC

    • Remove the four 22mm long Phillips screws around the side of the blower housing.

  6. ibhRDUGMWRNjl1wD
    ibhRDUGMWRNjl1wD
    SUL43XZX2OkTSBwq

    • Lift the blower housing upwards and slide it off of the blower assembly.

    • Remove the blower housing.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Arthur Shi

Mitglied seit: 03/01/18

218620 Reputation

Ein Kommentar

Were do you get the sticker?

JEFFREY -