Corsair Katar Scroll Wheel Replacement

Geschrieben von: Margaret Loughren
  • Kommentare: 0
Corsair Katar Scroll Wheel Replacement

Schwierigkeitsgrad

Moderate

Schritte

7

Zeitaufwand

10 - 15 Minuten

Einleitung

If the scroll wheel on your Corsair Katar mouse is not working properly, this guide will demonstrate how to replace it.

  1. Gomf6h1ntJAswYs6
    Gomf6h1ntJAswYs6
    DH4TgqdDULXjmsFA

    • Unplug your mouse before starting.

    • Flip the mouse over so the bottom is facing up.

  2. sAPDavweVwYGGRWp

    • Remove the three skates on the bottom of the mouse using the plastic opening tools.

    • Skates will be very sticky.

  3. L2sCyOVNb6wQ2xMZ
    L2sCyOVNb6wQ2xMZ
    VZ3siD2owmXEs5oE

    • Use the JIS 0 screwdriver to remove the four 5 mm screws on the bottom of the mouse.

  4. OpMQYwOdujvupbiW

    • Detach the bottom of the mouse from the upper shell.

    • Remove the shell slowly so as not to damage the white DPI cable inside the mouse.

    • Use the plastic opening tool to detach the white DPI sensor cable from its port.

    • Alternatively, you can use your hand to remove the DPI sensor cable by wiggling it out of the port.

  5. VvKaVXRMDIxHtPyM
    VvKaVXRMDIxHtPyM
    6hFsXVbt143pi3FU

    • Use the JIS 0 screwdriver to remove the two 5mm screws on the motherboard.

  6. YKOO14MQfaZbt4J3

    • Use the plastic opening tool to pry the white cable jack away from the motherboard.

    • Lift the motherboard away from the bottom of the mouse.

  7. QHhKtFJLtBYLgVkJ

    • Push the scroll wheel to the right side of the motherboard as shown, then pull it away from the board to remove.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Margaret Loughren

Mitglied seit: 12/07/18

594 Reputation

0 Kommentare