Cuisinart Griddler GR-4N Cooking Surfaces Replacement

Geschrieben von: Kayla Londono
  • Kommentare: 2
Cuisinart Griddler GR-4N Cooking Surfaces Replacement

Schwierigkeitsgrad

Moderate

Schritte

5

Zeitaufwand

10 Minuten

Einleitung

Cooking surfaces may be heating unevenly because the the plates and heating coils are out of alignment. This guide will take you through the steps to disassemble the device, allowing you to reassemble it correctly.

  1. 3JSUhroXuEcbdKZ2
    3JSUhroXuEcbdKZ2
    vKsvVmBN5dteiINP

    • Ensure device is turned unplugged, cooled down and clean before attempting any replacements.

    • Remove cooking plates by pushing in the tabs on each side of the plate at the same time.

  2. et1fD33cqagSWRaW

    • Remove the six 5.5mm Phillips #2 screws that secure the bottom heating coil to the device.

  3. 3uQEci5MBG6DsRnh

    • Remove the four 30 mm Phillips #2 screws that secure the bottom heating apparatus.

  4. YHpMsT3LhIQM1QB4

    • Remove the single 5.5 mm Phillips #2 screw next to center black button.

    • After removing the center screw the metal plate should be free to remove.

  5. wZb4JVHgCp6aQjMh
    wZb4JVHgCp6aQjMh
    kpjm4Jbls5fMNRDH

    • Lift the bottom heating apparatus up and remove large black center piece by pushing down on black button while sliding out.

    • Realign all surface and put device back together making sure all parts are lined up and heating surfaces are making contact.

    • The aligned parts will allow the cooking surfaces to work properly.

    Can you pls give your inputs as to how to fix the blinking light problem of the same Cuisinart model? In my sandwich maker and panini press both the left as well as the right knob light start flickering at the same time and the device wouldn't heatup

    Charu Bhardwaj -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Kayla Londono

Mitglied seit: 15/04/16

614 Reputation

Ein Kommentar

The 'cooking plates' on my unit always fall off. I tried bending the tabs to make it tighter - did not help. Any ideas?

M S -