Einleitung
To replace the firing mechanism of Carbine, you need to disassemble most of the Carbine. There will be oil in a few places and a few small parts.
Werkzeuge
-
-
Place the carbine with the saddle ring and leather thong facing upwards.
-
Locate the screw head on the cocking lever.
-
Place a #2 Phillips Screwdriver in the 11/16ths of an inch, matte black screw on the cocking lever assembly. Twist with a counter-clockwise motion.
-
Completely remove the screws.
-
-
-
Remove the cocking lever by placing your dominant hand’s fingers through the cocking lever handle.
-
With your fingers in the handle, slide the lever towards the butt of the carbine.
-
Finally, pull the cocking lever and carbine in opposite directions to replace the cocking lever.
-
-
-
Once the cocking lever is removed, place the carbine with the saddle ring facing upwards.
-
Locate the screws on either side of the saddle ring.
-
Using a #2 Phillips Screwdriver, twist in a counter-clockwise motion.
-
Completely remove the two screws.
-
-
-
Now rotate your carbine so the top of the carbine is visible.
-
Locate the screw located above the saddle ring where the black metal meets the wooden butt.
-
Using the same #2 Phillips Screwdriver, twist in a counter-clockwise motion.
-
Completely remove the screw.
-
-
-
Place your dominant hand on the wooden butt and your other hand on the metal barrel.
-
Slide the butt away from the Carbine until it is free of the metal tongs.
-
To reassemble your device, follow these instructions in reverse order.
