Dell Chromebook 11 3180 Battery Replacement

Geschrieben von: Devon Paul
  • Kommentare: 5
Dell Chromebook 11 3180 Battery Replacement

Schwierigkeitsgrad

Moderate

Schritte

8

Zeitaufwand

10 - 20 Minuten

Einleitung

The battery is a very common part to need to replace on a computer, especially as it becomes older. This is a very straightforward process and will only require removing a few screws and unplugging a cable. It should only take a couple of minutes, and there is little damage to be done.

  1. kK2ZURg2UJNDnSxP

    • Set your laptop upside down on your work space.

    I usually skip most all of this and start with the bezel, disconnecting the screen wire AT THE SCREEN, and not at the motherboard. 4 screws around the bezel, and 4 screws in the screen. Leave everything connected and skip to step 12.

    Denton Holland -

  2. SroJvXMZOGPYBNm3

    • Using tweezers, remove the circular stickers that are covering the two screws near the middle of the back cover. Stick them to the laptop next to the screws.

    -coordinate color of bullet points with markup

    -perhaps say "...in the middle of the back cover" instead of "at"

    Daniel Leon-Gijon -

  3. F5gT6g6IIH5hyGTA

    • Using a Phillips #0 screwdriver, loosen all seven 2.5mm screws on the back cover of the device.

    • These screws will stay attached to the back cover, so just loosen them until they rattle around.

    -coordinate color of bullets with markup

    Daniel Leon-Gijon -

  4. SFwKeE14cNHYLkYE

    • Using a plastic opening tool, begin to separate the back cover from the body of the computer.

    • If you have trouble prying a particular part of the back cover off, make sure that the nearest screws are fully loosened.

  5. GytiuSLFBHZClcbZ

    • Using your hands, pull the back cover fully off of the body of the computer.

  6. Y6crYUCLDf1kvSH3
    Y6crYUCLDf1kvSH3
    TjX6MBym5ka1KRtC

    • Unplug the battery from the motherboard by gently pulling the black cable header from the motherboard towards the battery.

    • You can locate this cable by checking that its other end connects to the battery. It has black protective wrap.

    -coordinate color of bullet with markup

    Daniel Leon-Gijon -

  7. RYuccZKNNcehUGji

    • Using a Phillips #0 screwdriver, remove each of the three 3mm screws from the battery.

    -coordinate color of markup with bullet

    Daniel Leon-Gijon -

  8. FlhMUgvKM1DZjgfJ

    • Lift the battery away from the computer to remove it.

    • If there is any resistance to the battery being removed, make sure that all of the screws have been properly removed and that nothing is blocking the battery.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Devon Paul

Mitglied seit: 26/04/17

1116 Reputation

0 Kommentare