Dell Inspiron 1521 Display Assembly Replacement

Geschrieben von: Christopher McCormack
  • Kommentare: 0
Dell Inspiron 1521 Display Assembly Replacement

Schwierigkeitsgrad

Difficult

Schritte

13

Zeitaufwand

30 Minuten

Einleitung

This guide will explain to you how to remove and replace the "lid" of the laptop, which contains the liquid crystal display (LCD screen).

  1. aVI5ZwmcS2aosLMI

    • Rotate the laptop so its bottom is facing up.

  2. TmGIwJwOYKMmUOGw
    TmGIwJwOYKMmUOGw
    JPcPVooeskgYityE
    NbJtdBVYOKHiOIrR

    • Identify the lock mechanisms holding the battery in place.

    • Slide each button outward with your fingers to disengage the battery.

    • Pull the battery off with your hand to separate it from the laptop.

  3. uYgnEgqcFyBqlKsJ
    uYgnEgqcFyBqlKsJ
    frsevMJ5LQiihTda
    QPvnuSnxtmmSYXZr

    • Find the two small indentations of the sides of the panel covering the power button.

    • Pry up both sides of the panel by sticking the plastic opener tool in each indentation and prying up.

  4. wetiIKQlMLSNGmbN

    • Now that the panel is loose simply pull the panel off with your hand.

  5. uxMVVSSHGVLk6CYL
    uxMVVSSHGVLk6CYL
    dvoZGsKTqgMBAILm
    YJDIDo5sbow2wqOI

    • Locate the two 5 mm Phillips #1 screws holding down the keyboard that were underneath the panel.

    • Remove these screws with a Phillips #1 screwdriver.

    • With the screws removed pull the keyboard up with your hand.

  6. U2mJTxYvARwRYdUB
    U2mJTxYvARwRYdUB
    lCGNJVGOKueXvh2r
    HVYLgAEgYoSdhHrp

    • Locate the connector that links the keyboard to the laptop.

    • Gently pull the connector toward the screen of the laptop with your figers to disconnect it.

  7. VIL6QtscqaeudbKH
    VIL6QtscqaeudbKH
    KhGxY1m1kbZpKKrL
    6OpJagTaqcStkInP

    • Locate the two Phillips #1 screws holding the Wireless Local Area Network (WLAN) panel in place.

    • Remove these two screws with a Phillips #1 screwdriver.

    • Remove the WLAN panel by pulling it up with your hand.

  8. aVo46Linhd2ZaThN
    aVo46Linhd2ZaThN
    XN5S4ZYbOGCfxMO5
    pUJrlH23d4B45o2E

    • Disconnect the black and white wires attached to the WLAN card by pulling up on the connectors with your fingers.

    • During reassembly, the black and white wires reconnect to the WLAN card near the black and white triangles, respectively.

    • Remove the remaining wires from their protective sleeve by hand.

    • The wires in the sleeve are only used in other Dell laptop models. During reassembly they do not connect to anything so just place them back into the sleeve.

  9. IcZ2N2LqHq4vuN1p
    IcZ2N2LqHq4vuN1p
    LCdZdvMtW6ErRLTO

    • Pull the wires that you disconnected in the previous step through the hole in the top of the laptop.

  10. fv2OJJcJoFHkdI3G
    fv2OJJcJoFHkdI3G
    pYoI1GgZWlvfXJMs
    NrFW5xDEFHkTRQsF

    • Detach the Phillips #1 grounding screw with a Phillips #1 screwdriver.

    • Disconnect the display cable by pulling up on the rectangular tab with your fingers.

  11. FkW12MHsRP2tIToF
    FkW12MHsRP2tIToF
    yJYFZhPF2bov5Khs
    hOLZh651wYEpNwCY

    • When disconnecting the camera/microphone cable, pull up by the white plug. Pulling on the cable itself can damage it.

    • Disconnect the camera/microphone cable by prying it upward with the plastic opener tool.

    • Separate the camera/microphone cable from the case by pulling it up with your fingers.

  12. yIjeGRjtJG2BprdX
    yIjeGRjtJG2BprdX
    ueMLt5JV5nCEBHWU
    rNvi2jWK4tYq6xqn

    • Remove the two 10 mm Phillips #1 screws from the bottom of the laptop that attach the lid assembly to the laptop with a Phillips #1 screwdriver.

    • Remove the two 10 mm Phillips #1 screws from the back of the laptop that also attach the lid assembly to the laptop with a Phillips #1 screwdriver.

  13. X4l43eCIlxxFlQXk
    X4l43eCIlxxFlQXk
    tvZybHAGgldxUjk4

    • There is a risk of dropping the lid or base of the laptop, or damaging cables. Make sure no cables are still attached.

    • Remove the lid by pulling it up from the base of the laptop with both hands.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Christopher McCormack

Mitglied seit: 27/09/12

42 Reputation

0 Kommentare