Einleitung

Guide to installing new RAM modules for the Dell Latitude D620.

  1. 2ahoN1SZaDunCRlW
    • Power down the laptop and remove the battery.

    • Open the laptop cover all of the way.

    Please help me

    manaqib arif -

    Mera display ka masla hai

    manaqib arif -

  2. bDghaIwVmHtPtMZQ
    bDghaIwVmHtPtMZQ
    C3GMiqK2KQ3YLX1n
    aSPCQC6EeTlfKx5Z
    • Locate the notch under the cover at the top of the keyboard

    • Using the spudger as a lever, lift the plastic covering

    • Carefully remove the rest of the covering from right to left

  3. BwGFsYFJ1MNJADcV
    • Unscrew the top portion of the keyboard using a #00 screwdriver

  4. QA5Oqh3xJYJcYJAc
    • Hold keyboard from the top and gently pull towards the LCD screen to remove the keyboard from the case

    • Don't pull on the keyboard too forcefully because it is attached to the motherboard with a short, thin ribbon cable

  5. GBUxtBDHiMMIo24Y
    GBUxtBDHiMMIo24Y
    EsL12USdc1aGVj4E
    • Once keyboard is out of the case, lay it face-down on the track pad

  6. TAuWhDomSD6ICOYh
    TAuWhDomSD6ICOYh
    gUBVXCcjkITVFUG1
    • Using a small spudger, pull back on the black bar to release the blue lever

  7. WxSRNoB5gxVV6DaX
    • Pull up on the metal bar connected to the socket to detach the ribbon cable

  8. IoGbjTKJQp6RWEAK
    IoGbjTKJQp6RWEAK
    FQGjSnLOHl56KxjH
    • With the keyboard removed, you should be able to see ram slot A.

    • Place new ram into the slot making sure it is aligned

  9. w3bFhHGPQXkjA6XN
    • Replace the keyboard by following the previous steps in reverse

    • Close the laptop, and flip it over onto its backside

  10. ydWsElGhPISVEEHq
    ydWsElGhPISVEEHq
    yO2ciI1T3kbwmfLD
    • Loosen the screw that holds the RAM cover in place.

    • The screw cannot be fully removed since it is attached to the RAM cover.

  11. JhaYOagIyQMsCP14
    JhaYOagIyQMsCP14
    3VERq1cRdDwWmtnE
    • Insert new ram into slot B

Abschluss

To reassemble your device, follow these instructions in reverse order.

Miguel Wong

Mitglied seit: 15/04/10

541 Reputation

2 Kommentare

If you are increasing the amount of RAM installed -> On first power on after installing the RAM, system on boot up will complain about memory size changed, and to reseat the memory. Wait for about 60 - 90 seconds, and you will receive a few additional messages about F1 to continue or F2 for Setup. Go into Setup and verify that the system sees all memory installed. If installing 2 x 2GB DDR2, max possible, 4GB. BIOS setup should report 4GB installed, of which 3.37GB usable.

Michael Erwin -

J’étais inquiet, mais en lisant votre commentaire, me voilà rassuré et j’ai donc suivi vos instructions. Ca fonctionne 2X2 GO …Merci

ppgauchard -