Dell Latitude X300 Palm Rest/Track Pad Replacement

Geschrieben von: Thomas Wong
  • Kommentare: 0
Dell Latitude X300 Palm Rest/Track Pad Replacement

Schwierigkeitsgrad

Moderate

Schritte

11

Zeitaufwand

20 - 30 Minuten

Einleitung

This guide is for the removal and installation of new track pad and palm rest of the Dell Latitude X300

  1. qICCXIaNXGcBEVkS

    • Before removing the battery from the laptop, make sure the power is off.

    • Push both battery locking clips outward at the same time.

  2. YWUnQZarvEKRYGVD

    • Slide the battery out of the laptop.

  3. fWK5E5Pb255TwcPK

    • Remove the four 4 mm Phillips #0 screws from the bottom of the laptop.

  4. nN2aFeYPRoMrkgly
    nN2aFeYPRoMrkgly
    rGpNKObhjS63iZvU

    • Carefully turn the laptop over and open the screen all the way.

    • Locate the slot to remove the keyboard in the lower left hand corner.

    • Using a spudger as a lever, insert it into the slot and gently pry up.

  5. boEVdtVrJcKA6RxD

    • After the keyboard pops up, pull it away from the screen just enough to release the tabs.

    • Don’t pull the keyboard out forcefully as there is still a ribbon attached to the laptop.

  6. kKhbEEF3gKqIO2Jp

    • Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.

  7. kOeXhhLvvOSDPENM

    • Remove the flexible ribbon from the ZIF connector.

    • Do not pull on the ribbon to remove it from the ZIF connector.

  8. h14Ce4Af6oBSelPi

    • Position the laptop so that the bottom is facing upward.

    • Remove the three 4 mm Phillips #0 screws holding the bottom of the palm rest.

  9. cV3S2FAOGUwTKMcv

    • Return the laptop to proper position and open the screen.

    • Remove the six 4 mm Phillips #0 screws holding in the palm rest.

  10. cDWFvMIUpCAxDpqV

    • Gently lift the palm rest and rotate it outward so that the bottom is now facing up.

    • The ribbon attached to the track is short and extremely delicate. Use care when moving the palm rest.

  11. h1mijPFDFao6jdDq

    • Lift up on the small ZIF connector and remove the ribbon.

    • If the ribbon seems stuck, gently wiggle it to remove. Do not pull the ribbon with great force.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Thomas Wong

Mitglied seit: 20/01/12

23 Reputation

0 Kommentare