Dell XPS 14 Back Panel Replacement

Geschrieben von: Kristen Gismondi
  • Kommentare: 0
Dell XPS 14 Back Panel Replacement

Schwierigkeitsgrad

Moderate

Schritte

4

Zeitaufwand

Keine Schätzung

Einleitung

  1. 6gvOkGxGLb4DZMf1

    • Position the computer back side up so that the “XPS” logo is facing you.

    • Remove six 3 mm screws along the perimeter of the back panel using a T5 Torx screwdriver.

  2. pqMaPbwsW6mNRLSV
    pqMaPbwsW6mNRLSV
    unXByc115ysYnHct
    xvFrsniTlp6uxmPR

    • Use an opening tool to pry up the metal plate.

    • Remove the two 6 mm screws under the silver flap using a Phillips #0 screwdriver.

  3. 52eScygypNIQFqBL
    52eScygypNIQFqBL
    UQerEtHL4HbV5PFN

    • Use an opening tool to pop out the back panel.

    • Once unhinged, the panel will open away from you.

    • The back panel will still be attached by a ribbon cable. Be cautious when opening the panel to ensure the ribbon stays intact.

  4. PRCFaaUHPUhAfqeY
    PRCFaaUHPUhAfqeY
    YTf6KCslomWRjXJk
    JUqWB5e5RNDgSXoy

    • Flip over the back panel so that the interior of the panel is facing up.

    • Remove three 2 mm screws that are connected to the vendor GCE disk on the bottom left corner of the back panel using a Phillips #0 screwdriver.

    • Remove the black plastic cover that holds the disk in place.

    • Remove the back panel.

    • The GCE disk should still be connected to the computer via a purple ribbon cable.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Kristen Gismondi

Mitglied seit: 12/11/14

71827 Reputation

0 Kommentare