Dell XPS M1710 Memory Replacement

Geschrieben von: Amia Frazier

Schwierigkeitsgrad

Moderate

Schritte

Zeitaufwand

Keine Schätzung

Einleitung

This guide will demonstrate how to replace the memory for the Dell XPS M1710.

NOTE: In order to take advantage of the dual channel bandwidth capability, both memory slots must be populated and must match in size
Memory modules purchased from Dell are covered under your computer warranty.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).
NOTICE: To avoid damaging the system board, you must remove the battery before you begin working inside the computer.
Ground yourself by touching one of the metal connectors on the back of the computer
Turn the computer over, loosen the captive screws on the memory module cover, and then remove the cover.

NOTICE: To prevent damage to the memory module connector, do not use tools to spread the memory-module securing clips
If you are replacing a memory module, remove the existing module:
Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
Remove the module from the connector

NOTE: If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.
Ground yourself and install the new memory module:
Align the notch in the module edge connector with the tab in the connector slot
Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove the module and reinstall it.

NOTICE: If the cover is difficult to close, remove the module and reinstall it. Forcing the cover to close may damage your computer
Replace the memory module cover.
Insert the battery into the battery bay, or connect the AC adapter to your computer and an electrical outlet.
Turn on the computer.
As the computer boots, it detects the additional memory and automatically updates the system configuration information. If prompted, press <F1> to continue.
To confirm the amount of memory installed in the computer, click the Start button, click Help and Support, and then click Computer Information.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Mitglied seit: 10/10/19

887 Reputation