Dewalt DCF885 Brush Assembly Replacement

Geschrieben von: Landon Smith
  • Kommentare: 1
Dewalt DCF885 Brush Assembly Replacement

Schwierigkeitsgrad

Easy

Schritte

10

Zeitaufwand

5 Minuten

Einleitung

This guide will assist you on how to replace a Dewalt DCF885 Brush. The brush assembly is used to conduct electricity to the armature as they rotate in one direction from brush to brush. This will allow the motor to turn depending on the armature.

The brushes may wear out over time thus requiring a replacement which can be referred to using this guide and the tools down below. Before beginning, use a knife to cut the middle of the sticker located at the base of the handle for ease when disassembling the part.

  1. D4mLSkWysGyj2GHT

    • Press the battery release button at the top of the battery.

  2. X2RPQDIawpY2QTa3

    • Pull the battery away from the tool.

  3. HRd5lhECTLEpJDie

    • Remove the eight 18 mm Torx Security #10 screws.

  4. Tpefd2EtpjY31LYq

    • Separate the two halves of the outer case. Set the empty side down and out of the way.

  5. nkLbAfvIU6rAs51x

    • Disconnect the connector from the motor assembly.

  6. pPGFJqOSbEFWOMaZ

    • Pull the motor away from the brush assembly.

  7. NYAcworWny4R2rOY

    • Lift the brush assembly out of the drill case.

  8. inPa1Li14G4Nf53V

    • Pull the armature assembly apart from the brush ring assembly.

  9. bEQj4VOMSINeoojO

    • Pry the two circled connectors apart from the brush ring assembly.

  10. xYJk3FYoSGwPYIww

    • The brush assembly is now removed from the drill body.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Landon Smith

Mitglied seit: 17/01/19

190 Reputation

Ein Kommentar

Can you tell me the exact model number of the unit in this tutorial? And/Or the part number for that switch assembly? I cannot find that specific switch assembly anywhere! Thank you.

Derek Tombrello -