Dewalt Nailers DCN660D1 2018 Back Support Replacement

Geschrieben von: Arthur Shi

Kommentare: 0

Dewalt Nailers DCN660D1 2018 Back Support Replacement

Schwierigkeitsgrad

Moderate

Schritte

Zeitaufwand

Keine Schätzung

Einleitung

This guide shows how to remove the back support assembly for the Dewalt Nailers DCN660D1 2018. The support needs to be removed in order to replace the driver or the control module.

Werkzeuge

Ersatzteile

Dewalt Support N378032

Schritt 1

Before you begin the repair, remove the battery from the device.

Schritt 2

Use a T10 driver to remove the ten screws securing the outer housing.
Some of these screws are deeply recessed. You can use a flathead screwdriver to loosen these screws.

Schritt 3

Lay the device on its left side (with the belt hook).
Lift and remove the right housing from the device.

Schritt 4

Remove the lock button from its recess.
During reassembly, make sure that the button is properly seated and engages the trigger.

Schritt 5

Slide the battery connector out of its recess.

Schritt 6

Remove the switch board from its housing recess.
Remove the two spring clips from the housing.

Schritt 7

During reassembly, use these photos to help you align all the loose parts back into the housing.
Be sure to route the wires through the yellow groove.
Be sure to reattach the spring clips.

Schritt 8

Carefully flip the device over.
Remove the left housing from the device.

Schritt 9

The spring under the release button has a tendency to fly out. Be careful not to lose the spring.
Carefully remove the release button from the device.
Remove the button spring from the device.