Dewalt Nailers DCN660D1 2018 Opening Procedure

Geschrieben von: Arthur Shi
  • Kommentare: 0
Dewalt Nailers DCN660D1 2018 Opening Procedure

Schwierigkeitsgrad

Moderate

Schritte

9

Zeitaufwand

Keine Schätzung

Einleitung

This guide shows how to remove the outer housing and open the Dewalt Nailers DCN660D1 2018 for further repairs.

  1. cVQdYFAkWBwF1jkU
    cVQdYFAkWBwF1jkU
    6QneiNayynNDJI4h
    6mAcC4BRgVw5VWPW

    • Before you begin the repair, remove the battery from the device.

  2. xanwoVYA3yXUIS1q

    • Use a T10 driver to remove the ten screws securing the outer housing.

    • Some of these screws are deeply recessed. You can use a flathead screwdriver to loosen these screws.

  3. pPK1kHoyNHSZcryX
    pPK1kHoyNHSZcryX
    WKpouGdaxZM16uGX

    • Lay the device on its left side (with the belt hook).

    • Lift and remove the right housing from the device.

  4. ilgumtWXBEb1MTZy
    ilgumtWXBEb1MTZy
    MpIKgohFKyFEBKym

    • Remove the lock button from its recess.

    • During reassembly, make sure that the button is properly seated and engages the trigger.

  5. ITIp5y2OLviCbtCj
    ITIp5y2OLviCbtCj
    AZCQdVguFhrkDGtb

    • Slide the battery connector out of its recess.

  6. xDFTvF323rMBYcdi
    xDFTvF323rMBYcdi
    PF4FIxtF3dbFaB1o
    xsVN3QjeDlQc4tUr

    • Remove the switch board from its housing recess.

    • Remove the two spring clips from the housing.

  7. eerZjmL6YNFEAmWk
    eerZjmL6YNFEAmWk
    JjYkuheAwgUlF1OK
    hm5aiXQqw261U2Fr

    • During reassembly, use these photos to help you align all the loose parts back into the housing.

    • Be sure to route the wires through the yellow groove.

    • Be sure to reattach the spring clips.

  8. qXuB6BH4S2JhR6UC
    qXuB6BH4S2JhR6UC
    aIqFrgTlChlVObKW
    tnSbO4m2FODkyjmI

    • Carefully flip the device over.

    • Remove the left housing from the device.

  9. YxhIIZMtBktCKkF2
    YxhIIZMtBktCKkF2
    G2PY53ahpFcUSxto
    XxJhNEmbcHvveqSw

    • The spring under the release button has a tendency to fly out. Be careful not to lose the spring.

    • Carefully remove the release button from the device.

    • Remove the button spring from the device.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Arthur Shi

Mitglied seit: 03/01/18

218620 Reputation

0 Kommentare