Disassembling Arnova 7K G3 Logic Board Ribbon Connectors

Geschrieben von: Kue
  • Kommentare: 0
Disassembling Arnova 7K G3 Logic Board Ribbon Connectors

Schwierigkeitsgrad

Moderate

Schritte

6

Zeitaufwand

10 - 15 Minuten

Einleitung

A device's logic board has many electrical connections to other components within the device. This guide, using the Arnova 7K G3 Rear Cover Removal guide as a prerequisite, shows how to remove the ribbon connections from the logic board, which may help in determining a bad ribbon connector or other faulty wiring.

  1. tFIeamAiXxtJmhLj
    tFIeamAiXxtJmhLj
    cqTO2r1GAL6LNlLC
    xY3SHZ53P5NWJkDY

    • Remove four 5 mm Phillips #00 screws from each corner of the tablet.

  2. DbjPDMok4l5GY3mQ
    DbjPDMok4l5GY3mQ
    2eJpYKGNgkOrfUOU

    • Place the iFixit opening tool in the notches between the cases and pull the covers apart.

  3. 33dcpCqAS1IqaGXN

    • Repeat step two until 3/4 of the rear cover is unlatched.

    • Proceed to remove the rear cover by gently pulling it apart by hand.

  4. mNdMOrRhhsHVqDHT
    mNdMOrRhhsHVqDHT
    esMylKAinvfGUPxL

    • Peel the copper tape covering the ribbon connector with a set of tweezers.

  5. qUTQKqEwgXLTdYRd
    qUTQKqEwgXLTdYRd
    SKPKIRcdbomNm2hT
    wyTdsBayRJURqSHq

    • Locate the two gray pins on the ribbon connector.

    • Grab the first pin with tweezers and gently pull it towards the ribbon. Repeat the step.

    • Gently pull the ribbon cable out of the connection port.

  6. qWn6TrRjRdJZftQR
    qWn6TrRjRdJZftQR
    wYbVqHBGClIVhDgc
    1nbDhfRckWqtAoHS

    • Locate the ribbon connector two.

    • Locate the pins of ribbon connector two. Repeat step two for unlocking the pins.

    • Gently pull the ribbon out of the connection port.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Kue

Mitglied seit: 18/03/15

301 Reputation

0 Kommentare