Disassembling Canon Pixma MP480 Rear and Side Panel

Geschrieben von: Kevin Cole

Kommentare: 3

Disassembling Canon Pixma MP480 Rear and Side Panel

Schwierigkeitsgrad

Moderate

Schritte

Zeitaufwand

20 - 30 Minuten

Einleitung

This guide will show you how to disassemble the back and side panel of the printer.

Werkzeuge

Schritt 1

Remove the two 7.9 mm screws using a Phillips #1 screwdriver.

Schritt 2

Lift up the back cover to remove it.
You may need to lift firmly as it requires quite a bit of force.

"quite a bit of force" is almost an understatement, I found 2 clips along the bottom of that rear piece, one at the far left one around the middle (indicated by an arrow on the underside of the machine) - undoing these required much persistence with a screwdriver

Perhaps Fuzz -

Schritt 3

Open the front tray.

Schritt 4

Open the scanner compartment.
Make sure the blue lever locks into place to keep the compartment open.

Schritt 5

Remove the blue lever from its slot by pushing it back and twisting clockwise.
Close the scanner compartment and cover.

Schritt 6

Pry open the side cover with the plastic opening tool.

Schritt 7

Flip the printer over so that you are facing the bottom of the printer.
Use the plastic opening tool to remove the corner of the side panel from the plastic pin.