Disassembling Canon PowerShot SD1100 IS Front and Rear Cover

Geschrieben von: Tyler Grossheim

Kommentare: 3

Disassembling Canon PowerShot SD1100 IS Front and Rear Cover

Schwierigkeitsgrad

Easy

Schritte

Zeitaufwand

10 Minuten

Einleitung

Use this guide to remove the front and rear cover of the Canon PowerShot SD1100 IS.

Werkzeuge

Phillips #00 Screwdriver

Schritt 2

Remove 2 screws from each side of the camera (4 total, 0.102 in).
Remove 2 screws from the bottom on the camera (0.138 in).
Do not mix the 4 side screws with the 2 bottoms ones; they are different sizes.

Schritt 3

Gently pull off the front cover.
The plate on the side should come off.
Gently pull off the back cover.

I had to remove the screw on the bottom mounting plate to get the front case cover off. The screw closest to the middle. The front plate does have a hole here that the screw goes through

remove both screws - the second holds the back plate

Michael Chalifoux - 26/05/22

This can be a bit tricky when reassembling. All of the little tabs around the edge need to snap into their proper places, and there are three cover pieces to manage. Plus, you need to make sure that the camera/video/playback switch is properly engaged with its slider on the circuit board, otherwise you'll need to raise the back panel and reposition everything again.

Craig Bonsignore -

oh yes , i agree lol

elbala80 - 09/03/16