Einleitung

This guide will show you how to remove the hard drive from your HP Compaq dx2000MT

  1. QqUIfbEFgWEoENc2
    • Turn off your computer and remove the power cable by pulling it straight out of its socket.

  2. TZBMYGU5xmCouAHI
    TZBMYGU5xmCouAHI
    XXkhfrfYF5k3YXoN
    • Remove the two Phillips #2 screws that secure the case door to the device.

  3. 3OpvPkfn4SA6ynv3
    3OpvPkfn4SA6ynv3
    UuZilQWYmFN4VQTC
    NEhXURB4ZrJWoWTA
    • Remove the side case door by pushing towards the rear of the device with your hand.

    • This may take considerable force so keep pushing!

    • Once you slide the door back, remove it by pulling it outwards from the device.

  4. N5AQDkScGdcXVN1O
    N5AQDkScGdcXVN1O
    VeMOUrXheEXxLxBu
    cFBdm1RJSZlEaPYp
    • Remove the side case door by pushing towards the rear of the device with your hand.

    • Once again, this may take considerable force.

    • Once you slide the door back, remove it by pulling it outwards from the device.

    it’s useless my friends

    bisous sur les fesses de ta mamaa

    Albert einstein -

  5. YlTsWEvvFXsthwwI
    YlTsWEvvFXsthwwI
    df1BADbwR2Y4sTNs
    ymruFWI5VgfeAOmB
    • Remove the IDE data and power cables from the hard drive.

  6. mOGkXKRJo2jZRCSQ
    mOGkXKRJo2jZRCSQ
    kuEnmwudGGBaAUrM
    QE2WRlykPv26TPQK
    • Remove the front bezel by pulling upwards and out from below the lowest air vent.

  7. ALGLFvojgVjNZDYs
    ALGLFvojgVjNZDYs
    D1s3WYyghUF6H1eU
    GFF6KRsSyq3uQ4YN
    • Remove the external drive faceplate by removing the two Torx T15 screws.

  8. WZHZk5w5oCVPxTJG
    WZHZk5w5oCVPxTJG
    hEuTvFaV4qHEnDBa
    • Remove the following screws:

    • Front Torx T15.

    • Torx T15 mounting the hard drive cage to the optical drive bay.

  9. DsBynyY5GiRva26b
    DsBynyY5GiRva26b
    fcPQNlNcTNHf2Ilr
    LDdNQJFxEdjMGLGI
    • Fully remove the hard drive cage by sliding it towards the back of the device and pulling down.

  10. uDGVShdaJdNKuMAH
    uDGVShdaJdNKuMAH
    BalIkIIkHl6YtcsC
    2ITYXbnyQU6UHjGT
    • Remove the two Torx T15 screws holding this side of the hard drive in place.

  11. uEHwOgCpSPxQ1VQm
    uEHwOgCpSPxQ1VQm
    4UQISvVGc1hCiZRV
    ihoCHSGYjnRkogH5
    • Proceed to the other side of the hard drive cage.

    • Remove the two Torx T15 screws holding this side of the hard drive in place.

  12. HaBSOIGR2JSgdQUT
    HaBSOIGR2JSgdQUT
    TXTggEonrZmwoESD
    • Remove the hard drive from the hard drive cage by pulling it outward from the cage.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Eva Pong

Mitglied seit: 23/09/11

101 Reputation

2 Kommentare

can i upgrade it to 500gb?

connor gouws -

This was a bit misleading. The title of the article is “Disassembling HP Compaq dx2000MT Hard Drive.” Therefore, I expected to see someone actually disassembling a hard drive, which would have been really cool. Instead, the article shows only the removal of a hard drive from a desktop computer’s case. Perhaps the title should say “Removing HP Compaq dx2000MT Hard Drive” or at best “Disassembling HP Compaq dx2000MT Case.”

Thomas Daniel -