Einleitung
Werkzeuge
-
-
The back panel (pictured left) has a black wire (end of wire circled red). The wire solders to the bottom right corner of the card drive.
-
The front panel (pictured right) has a black and red wire (end of wired circled green). This wire solders to a small circular spot next to where the black wire connects to the back (from above).
-
To reassemble your device, follow these instructions in reverse order.
2 Kommentare
To open the leappad top start with, remove battery covers and the 6 screws.
The two halves slide, bottom half towards cartridge slot, to make it harder they have used double sided tape on the bottom platic tounges, so a scredriver in the bottom will be needed to prize the slide.
Lawrence -
Good stuff. I'm trying to slide the back plate upward, but to no avail. You mentioned tape. Where exactly is it located?
John -