Disassembling Nerf Vortex Vigilon Inner Mechanism

Geschrieben von: Cara Pew
  • Kommentare: 0
Disassembling Nerf Vortex Vigilon Inner Mechanism

Schwierigkeitsgrad

Moderate

Schritte

3

Zeitaufwand

Keine Schätzung

Einleitung

  1. MXu2LaHXkCGV4GsD

    • Remove the seven #00 1 cm Phillips screws that attach the inner mechanism to the back cover.

    • Remove the #00 1.2 cm Phillips screw located to the right of the white casing.

  2. MstgZlYLEUWwUGBj
    MstgZlYLEUWwUGBj
    3eQKYUaTAEZe2Z6v
    AXMx6PhHUqoH5sQN

    • An orange block will likely fall out as you remove the front cover. The clip and spring will fall out as well, if they have not already.

    • Wiggle the front cover out from under the white piece and lift up from the gun.

    • Pulling the cover off is tricky due to its inner fitting.

    • Be sure to replace the orange block, spring, and clip before this step in reassembly.

  3. Hsx2YHitLfhjkYim

    • The spring, cap, and rotating lever will likely fall out as you remove the inner mechanism.

    • Disconnect the inner mechanism from the outer cover by lifting the inner mechanism towards you.

    • Be sure to replace the spring, cap, and rotating lever before this step in reassembly.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Cara Pew

Mitglied seit: 29/09/14

911 Reputation

0 Kommentare