Einleitung

Use this guide to separate the face plate from the amplifier.

  1. ix6KwcUJI5MwbjfJ
    ix6KwcUJI5MwbjfJ
    xnd5otveFW1OyKKF
    YWhJEXW3qGgwkjVY
    • Remove the two screws on both sides of the receiver. Keep these and the rest of the screws in a safe place.

  2. ejY1sGgG1WIqWN2O
    ejY1sGgG1WIqWN2O
    2IGKvJuX3cEHRhe6
    • Remove the top screw on the back panel.

  3. QHhfuxrID3Id52LM
    QHhfuxrID3Id52LM
    oRF6swHN6NrHJnv2
    • Slide off the case to expose the internal components of the receiver.

  4. BCIrXKYCdI111Xnh
    BCIrXKYCdI111Xnh
    KULhuCFK6b5JjeZF
    E4CPwK3dNGb1cAdc
    • Unscrew the three screws on top of the face plate.

  5. gakTkBkwLpjTLjSl
    gakTkBkwLpjTLjSl
    BH1Yi4pjprgduwa4
    • Unscrew the one screw on the bottom of the front panel.

  6. rqbmYGAhaEPPGrDf
    rqbmYGAhaEPPGrDf
    AkdXRM3WeMmHPQw2
    VJw33aqwIsQfgk4D
    • Simultaneously push down on the head of the snap on each end of the device with your thumbs and push to seperate the face plate. This may take some force.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ryan

Mitglied seit: 13/04/10

108 Reputation

2 Kommentare

I would like to remove Front Face plate of my Onkyo TX-SR875 AV Receiver. Please guide me how can I open it?

Ashish Solanki -

My Onkyo DX-C370 was “working fine..” until the belts started breaking. Following your disassembly and re-assembly guide, I replaced 3-belts using medium tension O-rings. Drawer opens/closes…, BUT carousel “studders” as it enters the pick-up unit, which does not engage with disk on “PLAY” button depression. I have Service Manual from online source.., and would like to follow “ERROR MESSAGE displays in “Heat-Running Mode” BUTY…, I do not know which panel button corresponds to the “DOWN BUTTON”.., Can You advise on how to get it spinning and playing CDs again..?

Much Thanks, Dom. Mendola, Ph.D. UCSD, Scripps Institution of Oceanography, Retired…

Dominick Mendola -