Disassembling Palm Centro Logic Board

Geschrieben von: Chelsea Barackman
  • Kommentare: 2
Disassembling Palm Centro Logic Board

Schwierigkeitsgrad

Moderate

Schritte

12

Zeitaufwand

5 - 10 Minuten

Einleitung

This will guide you on how to disassemble the Palm Centro to get to the logic board.

  1. yHZSDRcAUriIKSXA
    yHZSDRcAUriIKSXA
    D6yGOOgDk2ioBeAw

    • Press and slide open the battery cover.

  2. F2chW3VmD5lLQHHc

    • Caution: Turn cell phone off before removing battery!

    • Press battery to the right.

    • Then lift up battery pack to remove.

  3. I36kJJhwGSwC5hcc

    • Phone with battery removed

  4. KZwsZhQRSjSrsLNQ

    • Remove the touchpad pen from the top left corner on the back to reveal the last of 6 screws to be removed.

  5. OSnPHCFIPDFKaX3N

    • Lift the rubber cap at the top right to reveal the sixth screw.

    • Caution: There is a small Palm sticker under the rubber cap. Tampering with or removing this sticker will void your warranty!

    • Remove the six screws using the T5 Torx screwdriver.

  6. yfYSQZ4BTqRCvuuC
    yfYSQZ4BTqRCvuuC
    vrMC6OFoLRPZmdlL

    • Remove the SIM card so housing can be separated.

  7. 5ZeScpalMVMFcgmR
    5ZeScpalMVMFcgmR
    KJiKuDoBZWHWX5cY

    • Use a plastic pry tool to separate the bottom of the case to remove the small plastic insert.

  8. vIPI1TFIoaEBvvXq
    vIPI1TFIoaEBvvXq
    1lwBuZ1MSVqyyQWy

    • Remove the small plastic insert at the bottom of the phone.

  9. RBmHxM1XqfKpK6Cj
    RBmHxM1XqfKpK6Cj
    ktMHDfwBMAirwCfR

    • Continue with plastic pry tool all the way around the phone to remove the back housing.

  10. IoMuaapuGHAuvy4C

    • Carefully peel back the tape holding the speaker (left) and keyboard (right) connection tabs in place.

  11. CP2ySRRHVXNvXVKm

    • Using the plastic prying tool, lift the tabs and carefully pull the contact connections out on both sides.

    • Be very careful, these electronics are delicate!

  12. 1kOV4Xi5VxKChkKH

    • Separate the logic board from the case by lifting and pulling out the bottom.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Chelsea Barackman

Mitglied seit: 13/04/10

42 Reputation

2 Kommentare

note: if you need to replace the logic board, follow this guide, insert a new board, and then follow the steps in reverse order to get a working phone.

Chelsea Barackman -

i try to on this mobile ..but cant do that, i try to on this mobile so many ways.. i want to whhy thi mobile not on and how to resolve it?

kelumaruna -