Dremel 7300 MiniMite Cordless Motor-Shaft Assembly Replacement

Geschrieben von: Michael Smith
  • Kommentare: 0
Dremel 7300 MiniMite Cordless Motor-Shaft Assembly Replacement

Schwierigkeitsgrad

Easy

Schritte

4

Zeitaufwand

5 Minuten

Einleitung

If the motor burns up or the power switch breaks, you are going to need a whole new motor and shaft for the device, as they come as one piece. This guide will show how to dissemble and remove the motor-shaft assembly.

  1. RV1Yn5ZQdpfFGGQm
    RV1Yn5ZQdpfFGGQm
    y3TOuFqbNOA1nooD
    GJlhNfZPiCUW24at

    • Pull back on the release tabs to disconnect the battery pack from the housing.

    • When installing a new battery, you may need to charge it before using it.

  2. fHo2UgETsWxsRZFf
    fHo2UgETsWxsRZFf
    lI5WE2yPXXHSN4pQ
    RpIYElJgfYfkSCfS

    • Remove the two screws from the back of the device with the TR10 Torx Security screwdriver.

    • Make sure you have removed the battery before proceeding as accidentally powering-on the device while disassembling is dangerous due to the high-speed components inside.

  3. rLE5PL1OoTKoxjTi
    rLE5PL1OoTKoxjTi
    wAnTPJDMFEokwqxv
    6KtGtiW6URxOZ4mI

    • Lift off the unscrewed plastic cover at an angle, away from the tip of the device.

    • Gently lift the cover. It won't take much force to remove it.

  4. gF3mRZYWebNsJuQ3
    gF3mRZYWebNsJuQ3
    YRkiTqpxVicmyRjt
    RJmSoJfbuL5DAbhD

    • Lift the tip of the motor-shaft assembly gently, then pull the assembly out.

    • The blue battery contact and the spring for the shaft lock button may pop out when you remove the motor-shaft assembly. Make sure to keep track of these pieces, as they are very small.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Michael Smith

Mitglied seit: 10/02/16

175 Reputation

0 Kommentare