DualShock 3 Hauptplatinen-Baugruppe austauschen

Geschrieben von: Andrew Bookholt

Kommentare: 5

DualShock 3 Hauptplatinen-Baugruppe austauschen

Schwierigkeitsgrad

Mittel

Schritte

Zeitaufwand

Keine Schätzung

Einleitung

Werkzeuge

Kreuzschlitz PH00 Schraubendreher

Schritt 1

Entferne die einzelne 7,2 mm Kreuzschlitzschraube, mit der die Hauptplatine an der vorderen Abdeckung befestigt ist.

Most of the times, the only thing you need to repair to fix random key-presses is the soft plastic under the input-board connector to the motherboard.

At step 6 just move the motherboard upwards and you'll be able to see the connector.

Take the black soft-plastic-thing under it, and make it thicker with some tape. ( roll some tape around it 3-4 times - cut the tape properly so it can fit afterwards )

Now put everything back.

Random Presses are gone. Both of my controllers had this problem after a few hot summers and many hours of gameplay... both are fixed now.

Nick Preveza - 04/11/15

Schritt 2

Schiebe die Halterungen der Auslösetasten ein wenig von der vorderen Abdeckung weg.
Entferne die Tasten Nr. 1 auf beiden Seiten.

Schritt 3

Ziehe die Halterungen der Vibrationsmotoren von der vorderen Abdeckung weg, damit du die Hauptplatinen-Baugruppe ablösen kannst.

It should be noted that my controller (Australian) has the motors mounted directly the the housing. Once the two retaining screws were removed each motor was connected to the motherboard assembly by the wires alone.

Arthur N -

Yes, my NA controllers were like this as well.

geoff - 23/04/18

My ~2012 EU controller (CECHZC2E) differs from this point as well. The entire white assembly comes out of the black shell by pressing in the latches on both sides of the vibration motors (you can see a small bit of white plastic stick out from under the black shell, that is where you press down).

Martijn Storck - 08/12/17

Schritt 4

Entferne die Hauptplatinen-Baugruppe von der vorderen Abdeckung.
Drehe die vordere Abdeckung beim Entfernen der Hauptplatinen-Einheit nicht um, da sonst die Tasten und ihre Abdeckungen herausfallen können.

On my controller the button contact filament stayed inside the controller housing. Concerningly this exposed the contact ribbon for the buttons and sticks against the back of the logic board. However, the rest of the service with without issue, and the controller worked fine. This controller had a gray battery inside of it, and was likely a 60GB launch controller.

geoff - 23/04/18