Dyson DC39 Origin Steering Assembly Replacement

Geschrieben von: Luke Matusiak
  • Kommentare: 1
Dyson DC39 Origin Steering Assembly Replacement

Schwierigkeitsgrad

Easy

Schritte

3

Zeitaufwand

5 - 10 Minuten

Einleitung

Use this guide to replace the steering assembly of the Dyson DC39 Origin if you have damaged the wheels. This guide only requires one type of screwdriver and is very straightforward.

  1. ybue1JbUKJYIcNmZ
    ybue1JbUKJYIcNmZ
    EcWjK3tAMgOkoaud
    1K5Ki5o5BCyRWpQy

    • Push down on the gray button located next to the power button to release the bin from the ball housing.

    • Pull the bin away, then up from the ball housing to remove it.

    • If the bin won't fit back into place during re-assembly, you may need to push the grey button again.

  2. aopq3U3TsYjgAGIp
    aopq3U3TsYjgAGIp
    NgkB5wAi6sbVfIPu
    IFFQDJeTLmMYuRrL

    • Place the ball housing on its side and orient it so that the underside of the steering assembly is facing you.

    • Remove the four 18.0 mm Torx 15 screws.

  3. rOeNIc1YQQXXRTjS
    rOeNIc1YQQXXRTjS
    FqVGpnZcVOrCYgIb
    DFAxJ5KeEvfLCFEC

    • Using two hands, hold the ball housing with the handle in one hand and the steering assembly base in the other.

    • Hold the steering assembly base near one of the wheels.

    • Pull the steering assembly base directly away from the ball housing. You should notice a pin release.

    • Push up on the steering assembly to remove it completely from the ball housing.

    • During reassembly, slide the steering assembly in first, then push the pin back into its locking position.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Luke Matusiak

Mitglied seit: 26/04/17

479 Reputation

Ein Kommentar

Thank you, thank you, thank you!

Robin Hill -