EDCO Floor Stripper TS8 .75L (2017) Belt Replacement

Geschrieben von: Robert Boyd
  • Kommentare: 0
EDCO Floor Stripper TS8 .75L (2017) Belt Replacement

Schwierigkeitsgrad

Moderate

Schritte

7

Zeitaufwand

10 - 30 Minuten

Einleitung

Follow this guide to replace the belt on an EDCO Floor Stripper TS8 .75L (2017).

  1. DnshL2WqddCVCRL1

    • Before you begin, ensure the device is powered down and cool to the touch.

    • Ensure the machine is unplugged.

    • Turn the power switch counterclockwise into the OFF position.

  2. sFvpF2f1KB4f3AN3
    sFvpF2f1KB4f3AN3
    pD3EEpfVOrVgpIeV

    • Use a 1/2 inch socket to remove the four bolts securing the hood to the frame, two on each side.

    • During reassembly, ensure each bolt is reinstalled with both its flat washer and lock washer.

  3. UTqWmcpUp3aC4VGA
    UTqWmcpUp3aC4VGA
    auK5hfvipaKVhukE

    • Pull the hood away from the device to remove it.

  4. GOuR1m3axWEYfkuR
    GOuR1m3axWEYfkuR
    d4do5WhJhYVy5Lmc

    • Use a 9/16 inch socket to loosen, but not remove, the four bolts securing the motor mount to the frame, two on each side.

  5. UiaVVeRDPNAP3jYf
    UiaVVeRDPNAP3jYf
    ab1RDtAFfnxxVDhK

    • Slide the motor towards the front of the device to release tension in the belt."

    • Reassembly tip: Tilt the device onto its handles to use the weight of the motor to tension the belt, then tighten down the bolts.

  6. mkm6jUd2fsxneKFv
    mkm6jUd2fsxneKFv
    OT4mPo1yVauJHFqM
    bIFeT1avvDfCvw4Q

    • Remove the belt from the cam shaft pulley.

  7. VLDSXSwVcMwTQBXK
    VLDSXSwVcMwTQBXK
    rOIY5loEAS5n3I2t

    • Disengage the belt from the motor pulley.

    • Remove the belt.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Robert Boyd

Mitglied seit: 01/02/21

22262 Reputation

0 Kommentare