Etekcity Lasergrip 1080 Button Replacement

Geschrieben von: Patrick Crawford
  • Kommentare: 0
Etekcity Lasergrip 1080 Button Replacement

Schwierigkeitsgrad

Moderate

Schritte

8

Zeitaufwand

3 Minuten

Einleitung

This guide will teach you how to replace buttons that are not functioning properly. This will use a screwdriver and a plastic opening tool. There are no hazards involved.

  1. obB3lByTCoqYvRUO

    • Pull the battery cover away from the handle by gripping near the thumb groove.

  2. ctmGSaQ2TGtifROG

    • Gently pull the battery out of the handle.

    • Excessive force could damage wires.

  3. a2LiF3NQYAQUaPYB
    a2LiF3NQYAQUaPYB
    eLLJoJqEoxf2FdSI

    • Disconnect the battery by pulling the connector away from it.

    • Positive first

    • Negative second

    • When replacing the battery, this order is reversed.

  4. 1FA4PUHdCJVkbtZf
    1FA4PUHdCJVkbtZf
    sCEGVNcVRN5YjESj

    • Remove the battery cover from the device by pulling it straight out.

  5. 2pkWvb1qcFBSAqnd
    2pkWvb1qcFBSAqnd
    15wgfHxNNV4sxM3j

    • Using the plastic opening tool remove the front and rear yellow covers.

    • When removing the back cover, be careful not to lose the buttons as they are not connected.

  6. lWONdPGophDfPJTo

    • Remove the two 3.1 mm Phillips #0 screws.

  7. 4RWtuOUvAwpZZp2F
    4RWtuOUvAwpZZp2F
    YEQFh6oXMhtSdxgh

    • Pull the two halves apart.

    • Be careful not to lose any components on the inside.

  8. kLZHcrQCSHEtn3RP

    • Realign the buttons with the button terminals.

    • Red terminal to red button.

    • Orange terminal to orange button.

    • Yellow terminal to yellow button.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Patrick Crawford

Mitglied seit: 27/08/15

741 Reputation

0 Kommentare