Einleitung

This guide walks you through removing the brush roll cover. This is a necessary step to access the brush roll and the motor.

Werkzeuge

  1. tGO3aXEYGEkHcGDW
    tGO3aXEYGEkHcGDW
    AvQGgWkWGiBXGcfs
    • Place the device upright with the brush roller closest to you.

    • Pull up on the latch at the top of the dust cup.

    • Tilt the top of the dust cup forward and pull towards yourself, removing the container from the device.

  2. o4kaihoJ6UqGCgOb
    o4kaihoJ6UqGCgOb
    w3rjI36N2Nc3KIOM
    • Locate the gray exhaust filter cover at the top of the vacuum's base.

    • Grip the two tabs in the middle of the filter cover and rotate counter-clockwise.

    • Lift the cover away from the vacuum.

  3. gqEeRuDiXR5UyJ5Q
    gqEeRuDiXR5UyJ5Q
    WY3gEwvsJXFoaPkH
    EKQwu6SUv4CtlkDe
    • Pull up and unhook the two front tower latches using two fingers. These are located at the base of the tower.

    • Pull up and unhook the latch on the back of the tower.

    • Firmly lift the vacuum tower up and out of its stand.

    • The exhaust filter cover can be replaced once the tower is removed. It will not affect the steps.

    There is a screw on the back located left of the tab. What type of tool can take this out? It’s not a normal screw.

    meshaun9 -

    Actually there is no need to take off the top. I just completed steps 4-10 and It worked! :)

    meshaun9 -

  4. ZP6WVlWTByAPtEBG
    ZP6WVlWTByAPtEBG
    ODOVAeXQXr1xqheA
    • Remove the four 20mm screws on the top of the vacuum head's cover using a JIS 1 screwdriver.

  5. ZoyUip4wYARoejDs
    ZoyUip4wYARoejDs
    vVYW5PU5N4YUXKCq
    • Turn the vacuum head so that the back is facing you.

    • Press the handle release pedal.

    • Rotate the top of the motor cover down while pressing on the pedal release.

    • The motor cover should rotate from an upright position back towards the ground, as it would if the handle were still attached.

  6. 4jtuBbeMNI5fGjHT
    4jtuBbeMNI5fGjHT
    auBkp3KUxVAeFpZW
    mVMFfU3Kh4IbZJMx
    • Locate the two tabs on the back of the cover.

    • Pull up on the tabs and lift the cover away from the device.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Grayson Clendenon

Mitglied seit: 02/10/17

571 Reputation

0 Kommentare