Einleitung
Werkzeuge
Ersatzteile
-
-
open the right side of the Rockwheel's case, the side of the power switch. To access the screws, you need to pull the glued rubber protection a little. Once the case is open you'll see the PCB, the motherboard. You'll need to insert a jumper wire in two right holes on the bottom of the PCB.
-
-
-
Once the trip wire installed, simply switch on the Rockwheel. Be careful, it is very loud!
-
Wait for one long beep, 4 short beeps, and one long beep again. Then switch off the Rockwheel, remove the jumper wire, close the case, and you're done.
-
Abschluss
To reassemble your device, follow these instructions in reverse order.
What do you mean by “open the right side of the Rockwheel's case, the side of the power switch “. You know the power switch is in the middle and not on the side. What are you talking about?
alden_mirasol3000 -