Fluke 77 Series III Battery Replacement

Geschrieben von: Jessica Bombardier Shaw
  • Kommentare: 1
Fluke 77 Series III Battery Replacement

Schwierigkeitsgrad

Easy

Schritte

5

Zeitaufwand

5 Minuten

Einleitung

If the battery on your Fluke 77 Series III Multimeter needs to be replaced, this guide details the steps for doing so. Replacing the battery is a routine, but critical part replacement for the Fluke 77 Series III Multimeter.

  1. UEZKvKN5G41RZp4e

    • Be sure any test leads are out and the multimeter is off before opening the device.

    • Turn the multimeter so it is display side down.

    • Lift up the back stand of the device by putting your thumb in the curved well at the bottom of the device, so you have access to the two covered screws below.

  2. pi1E4ATuCGeXiKsZ

    • Use your Phillips #2 Screwdriver to remove the four black 21 mm Phillips #2 screws.

  3. BmtZv6urRe3PgYdD
    BmtZv6urRe3PgYdD
    2VZUikyocuNNxpGE

    • Turn the Fluke 77 Series III Multimeter back over so that it is display side up.

    • Pry the front panel from the back panel at the seam.

    • If the front panel does not come off easily, move a plastic opening tool along the seam until the panels separate completely.

  4. aFCBkPrNxCkAbQ5U
    aFCBkPrNxCkAbQ5U
    SATRvXmRmBieqxln

    • When doing this next step, make sure to remove the battery slowly, so you don't damage the wires connecting the battery to the device.

    • Locate the 9V battery in the lower right corner of the device.

    • Pull the battery out of its terminal.

  5. PyfZiBSKXyUGUcvD
    PyfZiBSKXyUGUcvD
    HAW4fRnIV1MuWGF2

    • Only pull on the metal snaps and battery. Pulling the cords may damage them.

    • Detach the two metal snaps from the battery.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Jessica Bombardier Shaw

Mitglied seit: 30/01/14

1006 Reputation

Ein Kommentar

Easy to understand and all went well!

petruskewichw -