Einleitung

How to remove and replace the logic board.

  1. Pkt3FmqJAJ4aQLDB
    • To prevent the danger of electric shock, remove the batteries before continuing to the next steps.

    • Slide the battery cover to the side to release the batteries.

  2. vmRqxIHXMXfnccM1
    vmRqxIHXMXfnccM1
    Fgu3NMD2PrESRQSM
    6yWExUFP3GMeI43j
    • Remove five screws from the camera casing using a tri-point Y0 screwdriver.

  3. fAhbFy25dmJLRN2h
    fAhbFy25dmJLRN2h
    wFY3hhf6RXgwDrsl
    • Grab the case with your hands and slowly pull back the outer casing.

  4. 4ajevGoBgvNcgrMu
    • Locate the LCD screen and anchoring screw.

    • Remove screw.

  5. eQXTqDBGiQWjfHOq
    • Carefully pull the LCD screen away from the board it is connected to.

  6. HwIDHLHKLbqNmSMZ
    • Push both blue switches away from the holding device to unleach lcd ribbon.

    • Be careful when removing ribbon. If you damage it, you will need to replace it as well.

  7. bMLVTGfgqxoHSQnS
    • Carefully detach the ribbon from where it was connected by the blue pins.

  8. E1BaJJrZ3cESyaiM
    • Now that everything has been disconnected from the board, remove LCD screen.

  9. TBJLP4wWVapldHRS
    • Remove the two screws holding the circuit board down.

  10. xOlWPjj1wryHrk53
    xOlWPjj1wryHrk53
    AiUE5c5F5eGvCGuo
    • Remove black sticky tape from circuit board and camera case.

  11. UHUaTvOGPLURWbIY
    UHUaTvOGPLURWbIY
    ZnXU4N4YDBxMCABZ
    • Gently pull the circuit board away from the front side of the camera.

    • Be careful when removing assembly as to not break any solder leads or damage lens assembly.

  12. gsOUCxgnKxyFIrus
    gsOUCxgnKxyFIrus
    qMu2OPBj3SLCeYS4
    • Remove the logic board by pulling straight away from assembly.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Cody

Mitglied seit: 19/04/10

47 Reputation

0 Kommentare