Einleitung

Can't hear anything? Replace the speakers once you get into the upper cover.

  1. A3q2YPgfXhNZgVsq
    A3q2YPgfXhNZgVsq
    RUaQLjlSQUFRhKDC
    vBsVE4BbKvTrbJSE
    • Unlock the tab located in the top left corner of the netbook.

    • The red tab indicated that the battery has been properly unlocked.

    • Remove the battery.

    • When working with electronics, it is always wise to remove the power source before taking the device apart.

  2. mcqtyJMt3ZMAO5Pf
    • Make sure the RAM, hard drive, and WiFi card have been removed from the computer before trying to take off the cover so they are not damaged in the process.

  3. YNeY4tRBqggTkxnD
    YNeY4tRBqggTkxnD
    ELIdYJGfYjcNEeo6
    • Remove six (6) 5mm screws, two (2) 17.5mm screws, and three (3) 2.5mm screws from the back, using the Phillips #0 screwdriver, as marked here.

  4. 6DNvmZBiaHWVYdiQ
    6DNvmZBiaHWVYdiQ
    xsJ1BCtFGSI1Smvj
    fOmTiduoIgGu5XvW
    • Pry up the keyboard using a spudger or plastic opening tool in the exact location shown in the photograph.

    • Don't use a screwdriver as a pry tool as shown in this example.

    • Carefully disconnect the keyboard ribbon cable from the motherboard, and remove the keyboard.

  5. UuChOPEDdVaVV3iP
    • Remove the five (5) 5mm screws shown here using the Phillips #0 screwdriver.

  6. KtQgfEyN46TdSMSO
    KtQgfEyN46TdSMSO
    IRULox4bCQkLJUmG
    • Separate the upper cover from the back cover. It is possible to do this without a tool, but you may also use a plastic opening tool for added leverage.

    • Be careful to keep even pressure all the way around the cover so that it is not bent beyond repair.

    • Carefully disconnect two ribbon cables to complete the separation of the upper cover.

  7. rjBATxnXtVcEhRyR
    rjBATxnXtVcEhRyR
    oJBlFWNviGNrxuRg
    • Remove the 5mm screw of the left speaker cover using a Phillips #0 screwdriver, as shown here.

  8. j625hPhGomMNgDyv
    • Disconnect the speaker's connection to the motherboard by lightly pulling on the connector until it pops apart from the motherboard.

  9. HcAGdtTXPxFUaQHV
    HcAGdtTXPxFUaQHV
    XWxyaJQBbqckYeXm
    • Repeat the previous steps for the right speaker. Remove the 5mm screw of the right speaker cover using a Phillips #0 screwdriver.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Lydia Benjock

Mitglied seit: 18/10/13

1216 Reputation

0 Kommentare