Einleitung
In order to replace the motors or circuit board for the car, you need to open up the enclosure where they are housed. Use the following steps to open the motor/circuit board enclosure.
-
-
Remove the 5mm Phillips #0 screw from the bottom of the car, located between the rear wheels.
-
Gently lift the battery cover from the car to expose the batteries.
-
-
-
Flip the car over and remove the four 5mm Phillips #0 screws that hold the shell to the car chassis.
-
-
-
Flip the car over again to its upright position and vertically lift the shell from the car.
-
-
-
Unscrew and remove the 5mm Phillips #0 screw located at the center of the wheel while holding the wheel still.
-
Slide the wheel off of the axle.
-
Repeat the previous steps for the other rear wheel.
-
-
-
Remove the eight 5mm Phillips #0 screws located on the top of the motor/circuit board enclosure.
-
Vertically lift the motor/circuit board enclosure from the car chassis.
-
-
-
Using a small plastic opening tool, gently pry the clips to release the tabs on the circuit board casing. The clips can be located above where the rear wheels used to be.
-
-
-
Lift the circuit board casing from the enclosure to reveal the motors, gears, and circuit board.
-
To reassemble your device, follow these instructions in reverse order.
