GoPro Hero5 Black Back Housing Replacement

Geschrieben von: Christopher Adams

Kommentare: 8

GoPro Hero5 Black Back Housing Replacement

Schwierigkeitsgrad

Moderate

Schritte

Zeitaufwand

10 - 15 Minuten

Einleitung

In this guide, you will be separating the motherboard assembly from the back housing. The GoPro Hero5 Black is waterproofed with plenty of adhesives. By completing this guide, you will have to remove the adhesive and your GoPro will no longer be waterproof.

Werkzeuge

Ersatzteile

GoPro Hero5 Black Display Assembly Housing

Schritt 1

While pressing the button on the bottom of the GoPro, slide the battery door to the side to pop it open.

Schritt 2

Grab the plastic flap on the battery and pull the battery out.

Schritt 3

Pull and twist the lens cover right or left until it pops off.
The lens cover is secured tightly and might be difficult to twist off.

レンズを回すには爪などをレンズカバーと本体との隙間に入れて、手前に引き出してから回転させます。

Taizo Yamamoto - 15/07/19

Go around the gap between the lens cover and camera body with a thin spludger to open a small gap and the cover will twist off easily.

Paul -

Schritt 4

This step is not necessary but will make the process of removing the faceplate much easier.
Refer to the iOpener instructions for how to heat up and use the iOpener.
Apply the heated iOpener to the front of the GoPro for a few minutes to melt the adhesive under the faceplate.
The heated iOpener is very hot and can burn your hands. Avoid burns by using towels or gloves to hold the iOpener.

Schritt 5

Starting with the edges, use the spudger to pry off the faceplate.
The faceplate is held down with adhesive and may take a while to get off.

Schritt 6

Remove the six T3 Torx screws.

Where can I get the screw driver

subashzeeq - 17/04/19

Mine are actually T4 screws.

John Hahn - 14/06/20

Schritt 7

Be careful when pulling open the motherboard assembly as it is still connected to the back housing by four cables. The cables may break if stretched.
Using the spudger, slowly pry open the motherboard assembly from the LCD side of the GoPro.

Little FYI ; pry slightly on the side with the LCD. Once it pops, work the other slightly. Then pull the board up and out but remember the cables. THE PICTURE ABOVE WHERE THE METAL SHIELD IS IS THE CAMERA LENS! CABLES ARE ON THE SIDE WHERE YOU BEGIN PRYING.

stevan othon - 05/12/17